Why don't we aim headlights anymore?
During the late 1980's, the Department proactively responded to vehicle inspection issues within the agency. During this period, legislation had been introduced to do away with the State Inspection Program. Many complaints had been brought to the attention of the agency and the Legislature on excessive charges by inspection stations for headlight aim.
The Department conducted a study and determined that:
By the late 80's most other states had stopped doing headlight aim testing. As a result through an administrative rule proposal that was approved on March 15, 1990, the headlight aim-testing requirement was removed from the inspection procedures chart.
How many license plates am I required to display?
State law requires that you display two (2) license plates, one to the front and one to the rear. Placement or mounting of license plates is not defined.
*This guidance is referenced in TXDOT's requirements to properly display the registration certificate. DPS does not inspect the license plate itself, but instead inspects the license plate lamp.
Will I fail my inspection if my windshield is cracked?
The windshield is NOT an item of inspection. However, the windshield wipers are. Be sure that the crack does not cause the wipers to tear and that the crack has not caused the windshield to become concave or convex so the wipers loose contact with the windshield.
If you need to obtain an inspection sticker, due to a cracked windshield, you will need to have your vehicle re-inspected. However, if your vehicle is registered in an emissions county, a replacement can be obtained through the DPS challenge/waiver station. Contact the waiver station to make an appointment. Fees for the replacement sticker is $14.50.
Waiver/Challenge Station Locations
Are seatbelts always a required item of inspection?
Seatbelts are a required item of inspection, on those vehicles in which front seat belt anchorages were a part of the manufacturers original equipment. When conducting a seatbelt check, front belts and anchorages are inspected.