Ready or Not

Setting the Record Straight on Readiness Monitors and On-Board Diagnostics (OBDII) Inspections


Readiness Monitor Status
Readiness Monitor Status is NOT the same as Diagnostic Trouble Codes (DTC's). Readiness represents whether or not the emissions control system in question has been evaluated. This evaluation tests for system functionality and, if a problem is detected, a DTC will be stored in the on-board computer.

back to top



What does "Ready" vs. "Not Ready" status mean?

back to top



Disconnecting the battery is the most common reason why monitors are "Not Ready"
Some reasons for disconnecting the battery are:

back to top


Where is Readiness Monitor Status on the Vehicle Inspection Report (VIR)?
The Emissions Tests Results section of the VIR shows the status of each readiness monitor.

Remember Effective October 15, 2008:
For vehicles year model 2001 and newer,  we allow one (1) non-continuous monitor to be Not Ready and still pass the test, but two (2) or more Not Ready's will cause the vehicle to fail.
For vehicles year model 1996 – 2000, we allow two (2) non-continuous monitors to be Not Ready and still pass the test, but three (3) or more Not Ready's will cause the vehicle to fail.

Emissions Test Results
MIL CMND Status: OFF Misfire: Ready Heated Cat: N/S 02Sensor Not Ready
  Fuel Sys: Ready Evap: Ready 02 Sensor Htr: Ready
MIL Engine On: PASS Comp Cmpnt: Ready 2nd Sys: Ready EGR Sys: Not Ready
MIL Engine Off: PASS Catalyst: Not Ready Air Cond: N/S    
Overall Result - FAIL            

back to top


Changing the monitor(s) to "READY"

*Vehicle manufacturer specific scan tools must be in the global OBDII or generic OBDII mode to display readiness monitor status.

back to top


If the vehicle has DTC's stored, and the MIL is commanded on:

back to top


IMPORTANT!!!
Automobile repair technicians need to check for service and recall bulletins that may apply to certain vehicles with readiness issues.

back to top